Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Improvements
#1
Just add a speed sensorĀ - reed contact and a magnet - to the setup to detect if the bike is moving. This could be used to detect downhill without pedalling or rolling towards a traffic light or standing... Would be only a few lines of code. Store actual speed, compare newe speed. Speed same or increased -> downhill, same or lower -> rolling towards a light. No crank, no speed -> standing.
Also, possibly decouple servo and actual pull at the bowden. Servos don't like constant pressure pull.


Messages In This Thread
Improvements - by Corkonian - 08-25-2020, 01:41 PM
RE: Improvements - by Jan Oelbrandt - 08-25-2020, 04:04 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)