Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ultegra 6800
#14
For the holdĀ  force I don't see why it would make much of a difference. The servo is fixed on the frame near the point where the cable runs. The cable runs w/o hose near to the derailleur, somewhat close the derailleur there is a stop. Another stop when using normal shifter is quite high on the frame, the hose that goes into the shifter normally goes there. Anyhow I can try that too. Attached pic shows the derailleur, I think similar to what you had in the video just that my cable from the hose to the servo is somewhat longer.


Attached Files Thumbnail(s)
   


Messages In This Thread
Ultegra 6800 - by Zaphod - 10-04-2020, 11:26 AM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-04-2020, 03:30 PM
RE: Ultegra 6800 - by Zaphod - 10-04-2020, 05:11 PM
RE: Ultegra 6800 - by visitor007 - 10-05-2020, 11:48 AM
RE: Ultegra 6800 - by Fesh - 01-13-2021, 01:20 PM
RE: Ultegra 6800 - by Jan Oelbrandt - 01-14-2021, 12:58 PM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-04-2020, 05:44 PM
RE: Ultegra 6800 - by Ed_R - 10-05-2020, 01:11 PM
RE: Ultegra 6800 - by Zaphod - 10-05-2020, 01:55 PM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-05-2020, 03:07 PM
RE: Ultegra 6800 - by Ed_R - 10-05-2020, 08:59 PM
RE: Ultegra 6800 - by Zaphod - 10-17-2020, 03:33 AM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-17-2020, 09:51 AM
RE: Ultegra 6800 - by Zaphod - 10-18-2020, 01:15 AM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-18-2020, 07:52 AM
RE: Ultegra 6800 - by Zaphod - 10-18-2020, 01:25 PM
RE: Ultegra 6800 - by Jan Oelbrandt - 10-18-2020, 02:47 PM
RE: Ultegra 6800 - by Zaphod - 10-22-2020, 08:32 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)