10-18-2020, 02:47 PM
Ok, that test-setup indeed should work.
The Calibrate script (obviously) doesn't have the overpull-release. So currents could be good as it is. If you upload the Derailleur script and measure current again, you'll see a whole lot less current while holding gear.
That being said, are you using the full range of your servo to go through all gears?
The Calibrate script (obviously) doesn't have the overpull-release. So currents could be good as it is. If you upload the Derailleur script and measure current again, you'll see a whole lot less current while holding gear.
That being said, are you using the full range of your servo to go through all gears?